6/21/2023 0 Comments Openmoko u bootDownload and extract Colibri_VF_LinuxImageVx.yz.tar.bz2 package with root permissions.Note: In case you are updating from older images, please follow the commands in the above section as applicable. If you update from a previous image use the following U-Boot commands:.Boot to U-Boot prompt and start the update:.Insert above prepared micro SD card into micro SD card socket (X10).Connect serial debug console to UARTA aka FFUART X13 using null modem RS-232 cable and a 10 pin IDC to 9 pin D-sub male connector.Insert above prepared SD card into SD/MMC socket (X15).X27 using null modem RS-232 or regular USB cable Connect serial debug console to UARTA aka FFUART (lower X25) resp.Run update.sh script with optional -o argument pointing to mount point of above mentioned card.micro D card with at least 1000 MB of free space Download and extract Colibri_T30_LinuxImageVx.yz.tar.bz2 package with root permissions.Use -v V1_1 option for V1.1b or V1.1c modules.Use -r 512 option for 512 MB RAM modules.Iris & EvalBoard V3.1a OK, for other carrier boards see here Make sure that the carrier board supports USB high speed.Short pin 1-2 of JP1 on Iris for recovery.Connect USB micro A/B (X12) to development workstation using regular micro USB cable. Press and hold recovery mode switch (SW9) during power up.Connect USB B (X29) or USB micro A/B (X30) to development workstation using regular or micro USB cable.Download and extract Colibri_T20_LinuxImageVx.yz.tar.bz2 package with root permissions.
0 Comments
Leave a Reply. |